Ghost Detector (Coffin) with Skull under A.I. control
This is the Ghost Detector Coffin with Skull - 1 piece. This consists of a microprocessor controlled EMF sensor that can be used as a stand alone "Ghost" or Lightning Detector. It can be combined as an array to cover much greater areas. You get an ultra-sensitive EMF Detector that feeds a microprocessor with limited A.I. control that can be used in your Paranormal investigations.
You will be amazed at what these devices can detect. With some experimenting, you can discover when and where to place the Ghost Detector for the best results. These are small enough that you can place them almost anywhere.
The Skull sits on top of an LED that will flash several times as it detects a presence. You will get 1 built & tested device. The detector will include a 9v Battery. There are 5 LED color options to chose from, the defaut LED color is BLUE. The coffin color is BLACK.
The Enclosure was custom designed and printed by us in Ocala FL. The Coffin has 4 mounting holes and 3 screw holes to access the battery. It is 3.7" long x 2.2" wide x 2.7" high (top of the Shull). There is a switch to turn the unit on or off.
For those technical folks (and I'm one) this circuit is a three-stage, un-tuned, wideband, Darlington LED amplifier that feeds a signal to a PIC microprocessor which will determine whether to flash the LED or not. There are no pulse-stretching circuits to extend the LED On-time. If there is enough energy present to forward bias the first stage, then all hell will break loose, figuratively speaking, of course. Under right conditions, it can pick up your aura (static electricity) as you walk across your rug. Designed by NightFire Electronics LLC, Ocala, Fl. USA.
We cannot be held responsible for whatever may be conjured up by this, you're on your own. If you feel a cold chill and the LED turns super bright and stays on ... run!