Ghost Detector DIY Kit - 1 piece (#13363)

Ghost Detector, DIY kit - 1 piece
Price: $10.99

This is Ghost Detector DIY Kit will give you the opportunity to convert most "things" to be an active Ghost Detector.

You can place the Ghost Detector in your favorite item and  watch it work. The LEDs will flash when it detects a "Ghost". The kit consists of a pre-assembled Printed Circuit Board, with two remoted LED "eyes" and a battery pack WITH batteries. It does have a small wire antenna attached to it.

NO SOLDERING required. Simply place the whole unit in your "doll" and put the LED "eyes" where they will have the best effect. You can hot glue the LEDs and the circuit in place.

The round battery compartment has two 3v lithium coin cell batteries already in place. There is also a switch on the battery compartment, make sure it is switched to "ON".

This Ghost Detector is an ultra-sensitive EMF Detector that can be used in your Paranormal investigations. You will be amazed at what these devices can detect. With some experimenting, you can discover when and where to place these Ghost Detectors for the best results. These are small enough that you can place them almost anywhere. The  LED eyes will come on as long as it detects a presence. It can come on briefly or stay lit longer, depending on the electrical fields in the area. Ghost body is not included.

For those technical folks (and I'm one) this circuit is a three-stage, un-tuned, wideband, Darlington LED amplifier using Bipolar Transistors. There are no pulse-stretching circuits to extend the LED's on-time. If there is enough lasting energy present to forward bias the first stage, then all heck will break loose, figuratively speaking, of course. Under right conditions, it can pick up your aura (static electricity) as you walk across your rug.

We cannot be held responsible for whatever may be conjured up by this, you're on your own. If you feel a cold chill and the LED turns super bright and stays on ... run!